HP TeemTalk Terminal Emulator 8 E-License Print By Pass Settings, Start Sequence, End Sequence

Print By Pass Settings

●Start Sequence

Factory default: Unspecified

This enables you to enter the character or sequence of characters that initiate a print bypass.

Characters can be entered in several ways. For example, to specify the ASCII escape character, you can enter either _027, \u001B, \e, \033, or even ^[.

●By Pass End Method

Factory default: Specify Sequence

You can select from the following print bypass methods: Specify Sequence, Count in Header or End on Non-Hex.

●End Sequence

Factory default: Unspecified

When the print bypass method is set to Specify Sequence, this enables you to specify the end sequence.

End sequence characters can be entered in several ways. For example, to specify the ASCII escape character, you can enter either _027, \u001B, \e, \033, or even ^[.

When an end sequence is specified, characters in the data stream between the start and end are interpreted as encoded ASCII. For example, 1B0A becomes ASCII 27 10 (ESC LF).

If no end sequence is specified, the bypass is assumed to be for a single pair of characters only.

●Length of End Sequence Factory default: 0

170 Chapter 16 IBM 3270 Printer Emulation