National Settings

These options enable you to select the character set to be used. There are separate entries for the Single Byte Character Set (SBCS) and (if supported) Double Byte Character Set (DBCS). These should only be changed by the System Administrator. If they have been changed and you wish to restore the default settings, click the Defaults button at the bottom of the dialog. The table at the end of this section shows the default settings.

National Codepage Settings Factory default: User Defined

This specifies the type of national codepage to be used. Selecting User Defined will enable manual selection of the Codepage and Character Set using the following options.

SBCS Codepage Factory default: 37

This is a numeric value specifying the single-byte character set codepage to use.

SBCS Character Set Factory default: 697

This is a numeric value specifying the single-byte character set to use.

DBCS Codepage Factory default: 0

This is a numeric value specifying the double-byte character set codepage to use.

Font

Setup Options 185