Specify the settings required by the host using the options described below, then click the Connect button.
●Communications Port Factory default: COM3This specifies the port used to communicate with the host.
●Baud RateFactory default: 9600
Specifies the connection speed in the range 110 to 115200 baud.
●ParityFactory default: None
This option specifies the parity mode for each transmitted character. If the number of data bits specified by Word Length is 8, set this option to None.
Selecting Odd will cause an eighth bit to be added with a value of 1 if the previous 7 bits add up to an even number, and 0 if the previous 7 bits add up to an odd number. Selecting Even will cause an eighth bit to be added with a value of 1 if the previous 7 bits add up to an odd number, and 0 if the previous 7 bits add up to an even number. Mark parity will set every eighth bit to 1 and Space parity every bit to 0.
●Word Length Factory default: 8This option specifies the number of data bits sent for each transmitted character.
●Stop Bits Factory default: 1This specifies the number of stop bits sent for each transmitted character.
●Flow Control Factory default: BothThis option specifies the type of flow control used by the line port to communicate readiness to transmit or receive data from the host.
Flow control setting | Effect on flow control |
|
|
None | No flow control. |
|
|
Input | XON/XOFF on received data. |
|
|
Output | XON/XOFF on transmitted data. |
|
|
Both | XON/XOFF on transmitted and received |
|
|
Hardware | RTS/CTS hardware flow control. |
Factory default: Unchecked
Serial Transport | 31 |