3.When you see the following message, immediately press F5:

Setup is inspecting your computer’s hardware configuration...

If you plan to install the operating system on disks attached to a ServeRAID controller, press F6 at this point so that you will be prompted to install the ServeRAID driver as well.

4.When you are prompted to select the Computer Type, as shown in Figure 4-3, select Other and press Enter.

Figure 4-3 Installing IBM custom HAL

5.Insert the xSeries 440 Windows 2000 HAL Support Disk (the one you downloaded and created) into the diskette drive and press Enter.

6.Select eServer xSeries 440 (Windows 2000 HAL), as shown in Figure 4-4 on page 114 and press Enter. The necessary files will be copied from the diskette.

Chapter 4. Installation 113

Page 127
Image 127
IBM 440 manual When you see the following message, immediately press F5