IBM 440 manual Installing the IBM PCI hot-plug controller driver

Figure 4-11 Shows the loaded Broadcom Gigabit driver

4. Select Continue and continue the NetWare installation as per usual.

Once the NetWare installation is complete, install the latest service pack. This can be done using the NWCONFIG utility.

Installing additional drivers

When the NetWare 6 and Support Pack installation has completed, you should perform the updates listed below. The order of these updates is not critical, but we recommend that you install the latest Support Pack prior to installing the device drivers.

￿Update the ServeRAID adapter driver.

￿Install the driver for Remote Supervisor Adapter (run SETUP.NLM, follow the instructions, and restart NetWare).

￿Install driver for PCI hot-plug controller, as described below.

Installing the IBM PCI hot-plug controller driver

1.Ensure that NetWare Support Pack 1 is installed, since it is required before the driver can be installed.

2.Download the PCI hot-plug driver from the link listed at the beginning of this section.

3.Copy the PCI hot-plug driver (IBMXSBD.NLM) to hard drive (C:\)

124IBM ^xSeries 440 Planning and Installation Guide