Figure 4-13 Shows that hot-plug is enabled

Tip: You can debug the driver by powering down the machine, rebooting, and entering:

LOAD C:\IBMXSBD.NLM -DBGALL > C:\IBMXSBD.TXT

Adding support for the RXE-100

To add support for RXE-100, a new NBI.NLM file must be obtained by going to http://support.novell.com/filefinder/ and searching for NBIUP1.EXE. This file contains a new NetWare Bus Interface driver, NBI.NLM. The new driver adds support for the x440 when the RXE-100 is installed.

Before you begin:

￿Attach the RXE-100 (do this after the NetWare installation).

￿The NetWare Support Pack must be installed before installing the new NBI.NLM. Otherwise, installing the support pack will overwrite the new

NBI.NLM

Perform the following operation:

1.Bring the server down to a DOS prompt.

2.Go to C:\NWSERVER directory and rename the NBI.NLM to NBI.OLD if it exists.

126IBM ^xSeries 440 Planning and Installation Guide

Page 140
Image 140
IBM 440 manual Adding support for the RXE-100, Before you begin