Verifying the IP settings
Note: On Windows computers, click Start 
Programs 
Command prompt (or Accessories 
Command prompt if using Windows 2000).
Attaching the scanner shelf
3Press Menu until you see Std Net Setup (or Network 1 Setup or Network 2 Setup), and then press Select.
4Press Menu until you see TCP/IP, and then press Select.
5Press Menu until you see Set IP Address, and then press
Select.
6Change the address by pressing Menu to increase or decrease each number. Press Select to move to the next segment. Press Select when you are finished.
The message Saved appears briefly.
7Press Menu until you see Set IP Netmask, and then press
Select.
8Repeat step 6 to set the IP Netmask.
9Press Menu until you see Set IP Gateway, and then press
Select.
10 Repeat step 6 to set the IP Gateway.
11 When you are finished, press Go to return the printer to the Ready state.
1Print another network setup page. Look under the “TCP/IP” heading and make sure the IP address, netmask, and gateway are what you expected.
See “Printing a network setup page” on page 20 if you need help.
2Ping the printer and verify that it responds. For example, at a command prompt on a network computer type ping followed by the new printer IP address (for example, 192.168.0.11):
ping xxx.xxx.x.xx
If the printer is active on the network, you receive a reply.
1Turn the printer off.
2Unplug the 16 AWG power cord or printer power cord from the grounded outlet.
Set up the printer
21
