Infinite Peripherals SCOM-100 1010,m,n,s, 1010,0,2,25, Setting a digital output after a delay

SCOM-100, User guide 29

This behavior is that of a monostable timer. The command to set an output with a pulse is:

1010,m,n,s
1010:	Command ID
m:	Module number (0 for SCOM-100 main
	unit, 1-8 for DI-42 I/O expansion units)
n:	Output number (1-4 for SCOM-100
	main unit, 1-2 for DI-42 I/O expansion
	units)
s:	Pulse duration in seconds (1-79200)

Test the pulse command by sending an SMS:

1010,0,2,25

4.4.5 Setting a digital output after a delay

A command is available to set a digital output with an initial delay time. The digital output’s switching behaviour is shown on the time-based diagram below.