Infinite Peripherals SCOM-100 manual 1020,m,n,h,mn, Resetting a digital output after a delay

SCOM-100, User guide 30

The command to set an output after an initial delay is:

1020,m,n,h,mn

1020:	Command ID
m:	Module number (0 for SCOM-100 main
	unit, 1-8 for DI-42 I/O expansion units)
n:	Output number (1-4 for SCOM-100
	main unit, 1-2 for DI-42 I/O expansion
	units)
h:	Delay on duration hours (0-21)
mn:	Delay on duration minutes (0-59)

4.4.6 Resetting a digital output after a delay

A command is available to reset a digital output with an initial delay time. The digital output’s switching behaviour is shown on the time-based diagram below.