Kyocera FS-6700 manual You have inserted the wrong memory card when the Insert

		Chapter 5 Troubleshooting
Message	Corrective Action
Insert the same	You have inserted the wrong memory card when the Insert
MEMORY CARD	again message was displayed. Remove the wrong memory card
	from the printer’s memory card slot and insert the correct
	memory card. The printer again reads it from the beginning of the
	data.
Format error	This message appears when the printer is in the ready state and
MEMORY CARD	the memory card is not formatted, and therefore cannot be read
	or written. Follow the procedure on Section 2.14. to format the
	card.
Warning battery	This message appears when the printer is in the ready state and
MEMORY CARD	the battery in the memory card is low. You can still enter the
	memory card mode, but the battery should be changed as soon
	as possible.
Battery error	This message appears when the printer is in the ready state and
MEMORY CARD	the battery in the memory card is dead, or there is no battery at
	all. It is not possible to use the memory card mode until you
	insert a good battery in the card.
MEMORYCARD err##	This message appears when an error occurs during access to
Press CONTINUE	the memory card using the PRESCRIBE IIe RWER (ICCD)
	command or from the printer’s control panel. Look at the error
	code given in place of ## and refer to the corresponding descrip-
	tion given below. Please note that error codes of 09 and above
	only result when memory card operations are done from the
	control panel.	(Continued on next page)

5-15