Chapter 1 Installing the Page Printer

Parallel interface

Plug one end of the cable into the connector marked Parallel () on the printer. Close the clips on both sides to hold it in place.

Plug the other end into a parallel (Centronics) interface connector on your computer. This connector is usually marked PRINTER.

See Appendix C for more details about the parallel interface.

Printer's Rear Side

Clips

Printer Connecting Cable

Serial interface

The serial interface of this printer is set to RS-232C mode before leaving the factory, but can also be set to RS-422A mode to suit your operating environment. Follow the instructions in Appendix C.

Serial Interface Connection

1.Plug the cable into the connector on the printer labeled “IOIOI”.

2.Securely tighten the screws on both sides of the connector.

3.Plug the other end of the cable into the serial interface connector on the computer. For details, refer to your computer’s hardware manual.

1-25

Page 50
Image 50
Kyocera FS-6700 manual Parallel interface, Serial interface, Serial Interface Connection