Configure

3. Configuring the Unit

You must configure the unit so that it can communicate on a network with your serial device. For example, you must set the way the unit will respond to serial and network traffic, how it will handle serial packets, and when to start or close a connection. You can configure your unit locally or remotely using the following procedures:

Use a standard Web browser to access the unit’s internal Web pages and configure the unit over the network. This is the easiest and preferred method.

Use a Telnet connection to configure the unit over the network.

Use a terminal or terminal emulation program to access the serial port locally.

The unit’s configuration is stored in nonvolatile memory (NVRam) and is retained without power. You can change the configuration at any time. The unit performs a reset after the configuration has been changed and stored.

Note: The configuration menus in this section show a typical device and all of the possible configuration options. Your device may have different configuration options.

3.1 Configuring via Web Browser

Open your JAVA enabled web browser and enter the IP address. The Lantronix Web Manager page will display. Go to Web Manager Page for a summary of the menu selections.

Note: The UDS-10-IAP may not have a web page or may use a different format web page.

UDS-10 User Guide

3-1

Page 41
Image 41
Lantronix 10 manual Configuring the Unit, Configuring via Web Browser