Lantronix 10 manual DeviceComm Manager

		Contents
	3.8.2 SNMP Community Name	3-25
	3.8.3 Disable Telnet Setup	3-26
	3.8.4 Disable TFTP Firmware Upgrade	3-26
	3.8.5 Disable Port 77FE (Hex)	3-26
	3.8.6 Disable Web Server	3-26
	3.8.7 Enable Enhanced Password	3-26
3.9	Factory Defaults	3-26
3.10 Exit Configuration Mode		3-27
3.11 Get Configuration		3-27
3.12 Set Configuration		3-28
4. Updating Protocol (Firmware)		4-1
4.1	Protocol Firmware	4-1
4.2	Reloading Protocol Firmware	4-1
	4.2.1 Via DeviceInstaller	4-2
	4.2.2 Via TFTP	4-4
	4.2.3 Via Another Unit	4-5
	4.2.4 Via the Serial Port	4-6
5. DeviceComm Manager		5-1
5.1	Installing DeviceComm Manager	5-2
	5.1.1 Install DeviceComm Manager	5-2
	5.1.2 Setup	5-3
6. Troubleshooting		6-1
6.1	Technical Support	6-1
	6.1.1 Technical Support	6-1
7. Monitor Mode		7-1
7.1	Monitor Mode	7-1
	7.1.1 Entering Monitor Mode Via the Serial Port	7-1
	7.1.2 Entering Monitor Mode Via the Network Port	7-1
	7.1.3 Monitor Mode Commands	7-1
8. Network Configuration using UDP		8-1
8.1	UDP Datagrams	8-1
8.2	Configuring Multiple Devices	8-3
	8.2.1 Acquiring a Valid Setup Record	8-3
	8.2.2 Sending a Setup Record	8-4
	8.2.3 The Intel Hex Format	8-5
	8.2.4 Calculating the Checksum	8-6
	8.2.5 Calculating the Two’s Complement	8-6
8.3	Setup Records	8-7
	8.3.1 Channel Parameters	8-8

UDS-10 User Guide iii