Lantronix 10 manual Function 5 4 3 2 1, Option

UDP

8.3.7 Flush Mode (Buffer Flushing)

Using this parameter, you can control line handling and network buffers with connection startup and disconnect. You can also select between two different packing algorithms. Use the following table to select Flush Mode options:

Table 29 - Flush Mode Options

Function

7 6 5 4 3 2 1 0

Input Buffer (Serial to Network)
Clear with a connection that is initiated from the			1
UDS to the network
Clear with a connection initiated from the network		1
to the UDS
Clear when the network connection to or from the	1
UDS is disconnected

Output Buffer (Network to Serial)

Clear with a connection that is initiated from the UDS to the network

Clear with a connection initiated from the network to the UDS

Clear when the network connection to or from the UDS is disconnected

1

1

1

Alternate Packing Algorithm (Pack Control)

Enable

1

Note: See Table 35 - Binary to Hexadecimal Conversion Table.

8.3.8 Pack Control

Alternate packing algorithm settings are enabled in Flush Mode. Use the following table to select Pack Control options:

Table 30 - Pack Control Options

Option	7	6	5	4	3	2	1	0
Idle Time
Force transmit: 12ms							0	0
Force transmit: 52ms							0	1
Force transmit: 250ms							1	0
Force transmit: 5sec							1	1
Trailing Characters
None					0	0
One					0	1
Two					1	0
Send Characters
Sendchars Define 2-Byte Sequence				1
Send Immediately After Sendchars			1

UDS-10 User Guide 8-13