
Monitor Mode
Table 17 - Monitor Mode Commands
Command | Command Name | Function |
DL | Download | Download firmware to the Device Server via the |
|
| serial port in hex format |
SF x.x.x.x | Send Firmware | Send firmware to Device Server with IP address |
|
| x.x.x.x |
VS x.x.x.x | Version | Query software header record (16 bytes) of |
|
| Device Server with IP address x.x.x.x |
GC x.x.x.x | Get Configuration | Get configuration of Device Server with IP |
|
| address x.x.x.x as hex records (120 bytes) |
SC x.x.x.x | Send Configuration | Set configuration of Device Server with IP address |
|
| x.x.x.x from hex records |
PI x.x.x.x | Ping | Ping Device Server with IP address x.x.x.x to |
|
| check device status |
AT | ARP Table | Show the Device Server’s ARP table entries |
TT | TCP Connection | Shows all incoming and outgoing TCP |
| Table | connections |
NC | Network Connection | Shows the Device Server’s IP configuration |
RS | Reset | Resets the Device Server’s power |
SI | Send/Set IP | Remotely assign an IP address to a Device |
xxx.xxx.xxx.xxx: | Address | Server, where xxx.xxx.xxx.xxx is the IP address, |
yyy.yyy.yyy.yyy |
| and yyyy.yyy.yyyy.yyy is the |
|
| number at the bottom of the label, converted to |
|
| decimal, and written twice. |
QU | Quit | Exit diagnostics mode |
G0, G1, ....,Ge, | Get configuration | Gets a memory page of configuration information |
Gf | from memory page | from the device. |
S0, S1,...,Se, Sf | Set configuration to | Sets a memory page of configuration information |
| memory page | on the device. |
Responses to some of the commands are given in Intel Hex format (see The Intel Hex Format on page
Note: Entering any of the commands listed above will generate one of the following command response codes:
Table 18
Response | Meaning |
0> | OK; no error |
1> | No answer from remote device |
2> | Cannot reach remote device or no |
| answer |
8> | Wrong parameter(s) |
9> | Invalid command |