Lantronix 10 manual Modem Mode Function Command, Atd

Configure

Table 11 - Modem Mode Commands

Modem Mode	Function
Command
ATDTx.x.x.x,pppp or	Makes a connection to an IP address (x.x.x.x) and a remote port
ATDTx.x.x.x/pppp	number (pppp).
ATDTx.x.x.x	Makes a connection to an IP address (x.x.x.x) and the remote port
	number defined within the unit.
ATD0.0.0.0	Forces the unit into monitor mode if a remote IP address and port
	number are defined within the unit.
ATD	Forces the unit into monitor mode if a remote IP address and port
	number are not defined within the unit.
ATDx.x.x.x	Makes a connection to an IP address (x.x.x.x) and the remote port
	number defined within the unit.
ATH	Hangs up the connection (Entered as +++ATH ).
	Enables or disables connections from the network going to the serial
	port.
	n=0 disables the ability to make a connection from the network to
ATS0=n	the serial port.
	n=1-9 enables the ability to make a connection from the network
	to the serial port.
	n>1-9 is invalid.
	Enables or disables character echo and responses.
ATEn	n=0 disables character echo and responses.
	n=1 enables character echo and responses.
	Enables 1-character response or full verbose.
ATVn	n=0 enables 1-character response.
	n=1 enables full verbose.

Note: These AT commands are only recognized as single commands like ATE0 or ATV1; compound commands such as ATE0V1 are not recognized. All other AT commands with Modem Mode set to full verbose acknowledge with an OK, but no action is taken.

3-20 UDS-10 User Guide