Lantronix Ethernet manual Interface Mode, Flow, Setup Mode Channel Configuration, Mode Option

Setup Mode: Channel Configuration

I/F (Interface) Mode

The Interface (I/F) Mode is a bit-coded byte entered in hexadecimal notation. The default setting is 4C.

Note: RS-422 and RS-485 are available on Channel 2 only.

I/F Mode (4C) ? _

The following table displays available I/F Mode options:

Note: All bit positions in the table that are blank represent “don’t care” bits for that particular option; they can be set to either a 0 or 1 value.

Table 7-1. Interface Mode Options
I/F Mode Option	7	6	5	4	3	2	1	0
RS-232C (1)							0	0
RS-422/485 4-wire							0	1
RS-485 2-wire							1	1
7 Bit					1	0
8 Bit					1	1
No Parity			0	0
Even Parity			1	1
Odd Parity			0	1
1 stop bit	0	1
2 stop bits(1)	1	1

(1) 2 stop bits are implemented by the software. This might influence performance.

The following table demonstrates some common I/F Mode settings:

Table 7-2. Common Interface Mode Settings
Common I/F Mode Setting	Binary	Hex
RS-232C, 8-bit, No Parity, 1 stop bit	0100 1100	4C
RS-232C, 7-bit, Even Parity, 1 stop bit	0111 1000	78
RS-485 2-wire, 8-bit, No Parity, 1 stop bit	0100 1111	4F
RS-422, 8-bit, Odd Parity, 1 stop bit	0101 1101	5D

Flow

Flow control sets the local handshaking method for stopping serial input/output. The default setting is 00.

WiBox2100E User Guide 51