![](/images/new-backgrounds/1110185/11018595x1.webp)
Setup Mode: Server Configuration
For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; only DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.) This is the most common setting when using DHCP.
Set Gateway IP Address
The gateway address, or router, allows communication to other LAN segments. The gateway address should be the IP address of the router connected to the same LAN segment as the unit. The gateway address must be within the local network. The default setting is N (No), meaning the gateway address has not been set. To set the gateway address, type Y and enter the address.
Set Gateway IP Address (N) ? Y
Gateway IP addr (000) (000) (000) (000)_
Netmask: Number of Bits for Host Part
A netmask defines the number of bits taken from the IP address that are assigned for the host part.
Netmask: Number of Bits for Host Part (0=default) (0) _
Note: Class A: 24 bits; Class B: 16 bits; Class C: 8 bits
The unit prompts for the number of host bits to be entered, then calculates the netmask, which appears in standard
Table
Network Class | Host Bits | Netmask |
|
|
|
A | 24 | 255.0.0.0 |
|
|
|
B | 16 | 255.255.0.0 |
|
|
|
C | 8 | 255.255.255.0 |
|
|
|
Change Telnet Configuration Password
Setting the Telnet configuration password prevents unauthorized access to the setup menu through a Telnet connection to port 9999 or through web pages. The password must have 4 characters. The default setting is N (No).
Change telnet config password (N) ? _
An enhanced password setting (for Telnet access only) of 16 characters is available under Security Settings on page 69.
Note: You do not need a password to access the Setup Mode window by a serial connection.
WiBox2100E User Guide | 48 |