Setup Mode: Channel Configuration
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : (000) (000) (000) (000)_
Note: This option does not display when Hostlist is enabled from the ConnectMode prompt (see Connect Mode on page 52 for more information).
Remote Port
You must set the remote TCP port number for the unit to make outgoing connections. This parameter defines the port number on the target host to which a connection is attempted.
Remote Port (0) ? _
To connect an ASCII terminal to a host using the unit for login purposes, use the remote port number 23 (Internet standard port number for Telnet services).
Note: This option does not display when Hostlist is enabled from the ConnectMode prompt (see Connect Mode on page 52 for more information).
DisConnMode
This setting determines the conditions under which the unit will cause a network connection to terminate. The default setting is 00.
DisConnMode (00) ? _
Notes:
In DisConnMode (Disconnect Mode), DTR drop either drops the connection or is ignored.
Note: All bit positions in the table that are blank represent “don’t care” bits for that particular option; they can be set to either a 0 or 1 value.
Table 7-7. Disconnect Mode Options
Disconnect Mode Option | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
|
|
|
|
|
|
|
|
|
Disconnect with DTR drop (6) | 1 |
|
|
|
|
Ignore DTR | 0 |
|
|
|
|
Telnet mode and terminal type setup (1) |
| 1 |
|
|
|
Channel (port) password (2) |
|
|
| 1 |
|
Hard disconnect (3) |
|
|
|
| 0 |
Disable hard disconnect |
|
|
|
| 1 |
State LED off with connection (4) |
|
|
|
|
|
Disconnect with EOT (^D) (5) |
|
| 1 |
|
|
|
|
|
|
|
|
(1)The WiBox sends the "Terminal Type" upon an outgoing connection.
(2)A password is required for a connection to the serial port from the network.
1
WiBox2100E User Guide | 60 |
