Lantronix Ethernet Enable Power Management

Setup Mode: Channel Configuration

WiBox2100E User Guide 66

Enable Power Management

This allows the software to turn off the radio when expecting not to receive or

transmit soon. This feature reduces the power consumption by up to 170 mA.

Enabling power management increases the response time, because the radio needs

to start up again. The radio is enabled to synchronize and check for incoming

messages (every 100 ms).

Note: This option is not available when the Topology is set to Adhoc.

Enable power management (N) ? _

Contents

Main WiBox2100E User Guide Copyright and Trademark Contacts Contents Page Page List of Tables List of Figures Page Additional Documentation Page Application Examples Serial Tunneling Network Ad Hoc Network Serial Tunneling Infrastructure Ad Hoc WiBox Connection WiBox with Ethernet Protocol Support Configuration Methods Addresses and Port Numbers Hardware Address IP Address WLAN Settings Port Numbers Serial Connector Pinouts WBX2100E Network Interface Ethernet Connector Pinouts LEDs Introduction WiBox2100E User Guide 18 Technical Specifications Page Installing and Configuring the WiBox Page Page Using Device Installer Viewing the Current Configuration Quick Start WiBox2100E User Guide 25 Page Page Network Configuration Automatic IP Address Configuration Static IP Address Configuration Ethernet Configuration Server Configuration Page Hostlist Configuration Channel 1 and Channel 2 Configuration Serial Settings Page Web-Manager Configuration WiBox2100E User Guide 35 Pack Control Flush Input Buffer (Serial to Network) Connection Settings - TCP Page Web-Manager Configuration WiBox2100E User Guide 38 Endpoint Configuration Common Options Connection Settings - UDP Page WLAN Configuration Page Web-Manager Configuration WiBox2100E User Guide 43 WEP Options WPA Options Advanced Settings Page Page Serial Port Connection Exiting Setup Mode Page Set Gateway IP Address Netmask: Number of Bits for Host Part Note: Class A: 24 bits; Class B: 16 bits; Class C: 8 bits Change Telnet Configuration Password DHCP Name Page I/F (Interface) Mode Flow Port Number Connect Mode Page Page Setup Mode: Channel Configuration WiBox2100E User Guide 55 Command String Result if remote IP is 129.1.2.3 and remote port is 1234 Page d) Datagram Type e) Modem Mode Page Send the Escape Sequence (+++) in Modem Mode Auto Increment Source Port Remote IP Address Remote Port DisConnMode Flush Mode (Buffer Flushing) Pack Control Packing Interval Trailing Characters Send Characters DisConnTime (Inactivity Timeout) Send Characters Telnet Terminal Type Channel (Port) Password WLAN Settings Enable WLAN Network Name (SSID) Adhoc Network Channel Security WEP WPA Fixed or Automatic Data Rate Transmission Data Rate Enable Power Management Page ARP Cache timeout in seconds CPU Performance Disable Monitor Mode at bootup HTTP Port Number MTU Size Security Settings Disable SNMP SNMP Community Name Disable Telnet Setup Disable TFTP Firmware Upgrade Disable Port 77FE (Hex) Disable Web Server Disable Web Setup Disable ECHO Ports Enable Enhanced Password Page Default Settings Channel 1 Configuration Channel 2 Configuration WLAN Settings Setup Mode: Advanced Settings Expert Settings Security Settings Exit Configuration Mode Page Page Page Using TFTP: Command Line Interface Network Upgrade Recovering the Firmware Using the Serial Port and DeviceInstaller To recover firmware: WLAN Country Setting Page Page Page Troubleshooting WiBox2100E User Guide 83 Problem/Message Reason Solution Page Technical Support Page Page Page Regulatory Information USA Federal Communications Commission (FCC) Notice Canada Industry Canada Notice Europe R&TTE Directive 99/5/EC, Wireless Notice Australia & New Zealand Wireless Notice