![](/images/new-backgrounds/1110185/11018577x1.webp)
Web-Manager Configuration
LED
Mode. The unit will not accept a data connection from a remote device when the hostlist option is enabled.
Select Blink for the status LEDs to blink upon connection or None for no LED output. The default setting is Blink.
Disconnect Mode
On Mdm_Ctrl_In Drop | Set to Yes for the network connection to or from the serial port |
| to drop when modem_control_in transitions from a high state |
| to a low state. The default setting is No. |
|
|
Hard Disconnect | When this parameter is set to Yes, the TCP connection closes |
| even if the remote site does not acknowledge the disconnect |
| request. |
|
|
With EOT | Select Yes to drop the connection when Ctrl+D or Hex 04 is |
| detected. Both Telnet mode and Disconnect with EOT must |
| be enabled for Disconnect with EOT to function properly. |
| Ctrl+D is only detected going from the serial port to the |
| network. The default setting is No. |
|
|
Inactivity Timeout | Use this parameter to set an inactivity timeout. The unit drops |
| the connection if there is no activity on the serial line before |
| the set time expires. Enter time in the format mm:ss, where m |
| is the number of minutes and s is the number of seconds. To |
| disable the inactivity timeout, enter 00:00. |
|
|
3.When you are finished, click the OK button.
4.On the main menu, click Apply Settings.
Connection Settings - UDP
To configure a channel’s UDP settings:
1.From the main menu, click Connection for either Channel 1 or Channel 2 to display the Connection Settings page for the selected channel.
Connect Protocol
Protocol
Select UDP from the
WiBox2100E User Guide | 39 |