Lexicon MPX G2 manual sources

MPX G2 Internal Controllers

Env is an envelope follower which creates an output that varies with the level of Env the Src parameter. You can choose any two audio level as sources. To follow

the levels on both Returns, set Src1 to Ret L and Src 2 to Ret R. Use Resp and ATrim to customize the response to level changes. Resp values below 50 take many seconds to “catch up” with audio level changes. For most situations, you’ll find values above 50 to be the most useful.

Env

Parameter	Range	Description
Src (1 or 2)	Off, In, Ret L, Ret R,
	FX1L, FX1R, FX2L,
	FX2R, ChrsL, ChrsR,
	EQL, EQR, RvbL,
	RvbR, DlyL, DlyR,
	PreOut, MainL, MainR
Atrim	0-100	Allows attack time to be shortened relative
		to overall response. 0=same as Resp,
		larger numbers shorten response.
Resp	0-100	Responsiveness

The rear panel Foot Switch jack can be connected to as many as three Footswitch Controllers independent analog switches. Each switch appears as two simultaneous patch

sources.

Tog1: Value toggles between 0 and 127 at each off/on transition of foot switch 1.

Tog2: Value toggles between 0 and 127 at each off/on transition of foot switch 2.

Tog3: Value toggles between 0 and 127 at each off/on transition of foot switch 3.

Sw1: Value is 0 when foot switch 1 is off, 127 when foot switch 1 is on.

Sw2: Value is 0 when foot switch 2 is off, 127 when foot switch 2 is on.

Sw3: Value is 0 when foot switch 3 is off, 127 when foot switch 3 is on.

8-3