![](/images/new-backgrounds/1110169/110169125x1.webp)
Operation
Remote Monitor Panel
The Liebert Remote Monitor Panel provides an LED indication of the following conditions:
•Load On UPS
•Load On Bypass
•Battery Discharge
•Low Battery Warning
•Overload
•Ambient Overtemp
•System Summary Alarm
•New Alarm
This information is also available for customer use through a set of contacts on a separate terminal board.
Alarm messages that activate the System Summary Alarm are listed in Table 1 and Table 2.
The Remote Monitor Panel housing is a NEMA Type 1 enclosure, available for either
Separate / Simultaneous Outputs
The
Table 6 | Series 610 terminal commands | ||
|
|
| |
| Key(s) | Function | |
|
|
| |
A, return |
| Displays Present Status Report screen. | |
|
|
| |
^B | Displays Event History Report screen, starting with the most recent frame and then | ||
scrolling back through earlier frames. | |||
|
| ||
C, return |
| Displays History Status Report screen starting with the most recent frame and then | |
| scrolling back through the earlier frames. | ||
|
| ||
F (no return) | Freezes data output. This stops the data scrolling on the monitor to allow closer study or a | ||
printout. This is a toggle switch command. Press the “F” key again to resume data scrolling. | |||
|
| ||
|
| Resets (unfreezes and clears) the History Status Report memory buffer. This erases the | |
G, return |
| alarm messages and meter indications that were stored immediately before and after a | |
| significant system fault. NOTE: Do not reset the History Status Report memory buffer until | ||
|
| ||
|
| operation and maintenance personnel have reviewed it as a troubleshooting tool. | |
|
|
| |
|
| The data output stops (quits). The UPS communication system remains on | |
Q (no return) | to receive the next communication command. NOTE: To return to the beginning of the | ||
|
| Event History or History Status Report, press Q, then request your desired report again. | |
d mm/dd/yy, return | This entry sets the date (month/day/year) in the UPS system clock. You must include the | ||
slash (/) as you key in the date. Note that the d command must be lower case. | |||
|
| ||
t hh:mm:ss, return | This entry sets the time (hour:minute:second) in the UPS system clock. You must include | ||
the colon (:) as you key in the time. Note that the t command must be lower case. | |||
|
| ||
H, return |
| Prompts the UPS system to hang up its modem (only applicable to the modem | |
| communications port). | ||
|
| ||
I, return |
| Display Battery Cycle Monitor information for | |
|
|
| |
J, return |
| Display Battery Cycle Monitor information for | |
|
|
| |
K, return |
| Display Battery Cycle Monitor information for | |
|
|
| |
L, return |
| Display Battery Cycle Monitor information for over 240 second discharge events. | |
|
|
| |
M, return |
| Display Status Summary screen of battery discharge events. | |
|
|
| |
N, return |
| Show detail information on all battery discharge events in order of occurrence (last in, first | |
| out). | ||
|
| ||
backspace |
| Moves cursor left to cancel previous entry or command. | |
|
|
|
57