Lifescan SPD2410BD manual Beep Signals

United States. If you are not sure which unit of measurement to use, please check with your Health Care Professional. The mmol/L results include a decimal point and the mg/dL results do not.

To change the unit of measurement to mg/dL, press the green C button. This symbol will flash on the display.

S E T T I N G S

Press the blue power button to move to the beep signals setting.

Beep Signals

The OneTouch® SureStep® Meter uses beep- ing tones to signal certain steps in the proce- dure. However, these “beep” signals do not mean that the step was performed correctly. Three types of beep signals sound.

1. A single, short beep identifies each step in the test procedure.

2. A single, long beep accompanies error messages, a “HI” result, and certain mis- takes in doing the test procedure.

3. A three–tone beep sounds when the meter displays a test result and when the meter moves to the beep signal feature in set–up mode.

62