Return to Section TOC
Return to Section TOC
Section TOC
Return to Master TOC
Return to Master TOC
to Master TOC
OPERATION
CONTROLS AND SETTINGS
All welder/generators controls are located on the Output Control Panel. Gasoline engine controls are mounted on the engine. See Figures B.1 and B.2 and the explanations that follow.
FIGURE B.1 – OUTPUT PANEL CONTROLS
9 | 1 |
|
10
8
| 2 |
|
|
| 7 |
|
|
|
|
| |
| 3 |
| 5 |
| |
| 4 |
|
| 6 |
|
|
|
|
|
| |
1. | CURRENT CONTROL DIAL | 6. | 20 | AMP CIRCUIT BREAKERS (2) (15 AMP CSA) | |
2. | ELECTRODE SELECTION GUIDE | 7. | 20 | AMP, 230 | VOLT RECEPTACLE (15 AMP CSA) |
3. | WELD POSITIVE OUTPUT TERMINAL WITH 1/2 - 13 FLANGE NUT | 8. | 20 | AMP, 115 | VOLT DUPLEX RECEPTACLE (15 AMP CSA) |
4. | WELD NEGATIVE OUTPUT TERMINAL WITH 1/2 - 13 FLANGE NUT | 9. | HOUR METER | ||
5. | GROUND STUD | 10. IDLER CONTROL SWITCH | |||
Return to
Return to Section TOC
Return
Return to Master TOC
WELDER/GENERATOR CONTROLS
See Figure B.1 for the location of the following fea- tures:
1.CURRENT CONTROL DIAL: Adjusts continuous current output. The amperages on the dial corre- spond to the average amperages needed for spe- cific Lincoln welder rods.
2.ELECTRODE SELECTION GUIDE: Provides rec- ommended electrode type, size, and welder out- put setting based on the thickness of the work.
3.WELD POSITIVE OUTPUT TERMINAL WITH 1/2 - 13 FLANGE NUT: Provides the connection point for either the electrode holder or the work cable. (For DC+ welding the electrode holder should be connected to the Weld Positive Output Terminal and the work cable to the Weld Negative Output
Terminal. For DC– welding the electrode holder should be connected to the Weld Negative Output Terminal and the work cable to the Weld Positive Output Terminal.)
4.WELD NEGATIVE OUTPUT TERMINAL WITH 1/2 - 13 FLANGE NUT: Provides the connection point for either the electrode holder or the work cable. (For DC+ welding the electrode holder should be connected to the Weld Positive Output Terminal and the work cable to the Weld Negative Output Terminal. For DC– welding the electrode holder should be connected to the Weld Negative Output Terminal and the work cable to the Weld Positive Output Terminal.
WELDANPOWER 125
