Figure F.3 Brushes Retained with Cable TIE | Lincoln Electric SVM 113-A

Return to Section TOC

Return to Master TOC

F-17

TROUBLESHOOTING & REPAIR

ROTOR RESISTANCE TEST (continued)

FIGURE F.3 – BRUSHES RETAINED WITH CABLE TIE

CABLE

TIE

BRUSHES

9.Reinstall the brush holder assembly after the test. Depress the spring-loaded brush- es into the holder and slip a suitable non- metallic, fairly stiff retainer through the slots at the top and bottom of the holder. A cable tie works well; see Figure F.3. This will hold the brushes up so that you can easily install the holder.

10.Slip the holder into position in the genera- tor end bracket. Be careful not to loosen the 2 attached wires.

11.Reinstall and tighten the 2 screws with the 1/4” nut driver.

12.Slowly remove the non-metallic retainer from the brush holder and let the brushes snap back against the slip rings.

13.Snap the brush holder cover back into position.

WELDANPOWER 125

Lincoln Electric SVM 113-A service manual Figure F.3 Brushes Retained with Cable TIE

Models: SVM 113-A

TROUBLESHOOTING & REPAIR

ROTOR RESISTANCE TEST (continued)

FIGURE F.3 – BRUSHES RETAINED WITH CABLE TIE