Navigate to a Waypoint
You can select any waypoint visible on the Map Page with the cursor, then use the Navigate to Cursor command. However, you can avoid scrolling the map to pick your waypoint if you use the Find commands:
1.Press FINDENT. To look up the nearest waypoint, press ENT, or to look by name (and scroll through the entire waypoint list), press ↓ENT. For this example, look by name.
2.If your waypoint list is a long one, you can spell out the waypoint name in the FIND BY NAME box to search for it. (Press ↑ or ↓ to change the first character, then press → to move the cursor to the next character and re- peat until the name is correct, then press ENT to jump to the list below.)
3.If the list is short, you can jump directly to the FIND IN LIST box by pressing ENT. Use ↑ or ↓ to select the waypoint name, press ENT and the waypoint information screen appears with the GO TO command selected.
4.To begin navigating to the waypoint, press ENT.
Navigate a Trail
1.Press MENUMENU↓ to MY TRAILSENT and a screen similar to the one below appears.
Trails Menu.
2.Press ↓ then use ↓ or ↑ to select a trail to navigate.
3.With the trail name highlighted, press ENT↓ to NAVIGATEENT.
4.Wait while iFINDER creates a route from the trail. When the prog- ress message disappears, the unit displays a trail information screen, with the NAVIGATE command highlighted in the top command box.
41
