Installation and Operation |
Installing a Single User
You can connect a single user to a SURFboard cable modem using the USB or Ethernet port. Allow 5 to 30 minutes to power up the first time because the SURFboard cable modem must find and lock on the appropriate channels for communications. To install the SURFboard cable modem for a single user:
1Be sure the subscriber’s computer is on and the cable modem is unplugged.
2Connect one end of the coaxial cable to the cable outlet or splitter (Always make the wall connection first). Connect the other end of the coaxial cable to the CABLE connector on the cable modem.
Figure
Cable connections
To 
Ethernet or USB
ETHERNET |
|
|
USB |
|
|
CABLE |
|
|
USB CPEMAC ID:ABDCEF012345 | S/N: PPPPMMYJJJSSSSSCAABBCCCC HFC MACID: ABCDEF012345 | CUSTOMERS/N:BCDFGHJKLMNP |
+12VDC |
To cable outlet
To power outlet
3Insert the SURFboard Cable Modem
4Plug the power cord into the +12VDC connector on the cable modem and the electrical outlet. This turns the SURFboard cable modem on. The cable modem does not need to be unplugged when not in use.
5Check that the LEDs on the front of the cable modem cycle through this sequence:
#POWER flashes during the
#RECEIVE flashes while scanning for the receive channel and changes to solid green when the receive channel is locked.
#SEND flashes while scanning for the send channel and changes to solid green when the send channel is locked.
#ONLINE flashes while the cable modem downloads configuration data and changes to solid green when the download is complete. Configuration data includes the DHCP server IP address, configuration, and time and date stamp.
