15:USER LANGUAGE: This function allows you to switch between the two languages programmed into your fax machine.
16:INCOMING RING: This function controls the telephone ringing sound your fax machine makes when a call comes in. Available settings are on and off.
17:REMOTE RECEIVE: When you receive an incoming call, this function allows you to remotely tell your fax machine to switch from telephone to fax mode to receive an incoming fax. To use this function, use the keypad of a handset or an external telephone to enter the remote receive number you have programmed into your fax machine. Available settings are off, 00, 11, 22, 33, 44, 55, 66, 77, 88, 99, ** and ##. This function only works if your telephone system is a tone dialling system.
18:MEM./FEEDER SW.: This function controls how your fax machine normally transmits fax messages to one location. Either scanning the document into memory first and then start dialling, or by transmitting directly from the document feeder after dialling. Available settings are MEM. and FEED.
19:POWER SAVE MODE: This function substantially reduces the amount of power your fax machine consumes when it is not in use. When this function is on, your fax machine automatically switches to power save mode after it has been idle for three minutes. When this occurs, your display shows: POWER SAVE MODE, PRESS“START” TO EXIT. While in this mode, your fax machine automatically switches back to full operation after you press the Start key, when the telephone rings, when the telephone handset is lifted, or when a document is loaded. Available settings are on and off.
20:ECM FUNCTION: The error correction mode function helps your fax machine to improve communication in areas where telephone line conditions are poor. Available settings are on and off.
Note:
When using ECM, the transmitting fax machine automatically checks the data as it is sent. If the receiving fax machine cannot verify the transmission, the transmitting fax machine will retransmit as necessary. Using ECM also increases transmission time because the data is checked as it is transmitted.
68 | User’s Guide |
