Olivetti 4501MF, 3501MF operation manual Warranty, Mains Plug Wiring Instructions

In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON" and "OFF".

The symbol " " denotes the copier is not completely de-energized but in a stand-by condition at this "POWER" switch position.

If your copier is so marked, please read "I" for "ON" and " " for "OFF".

Caution!

For a complete electrical disconnection, pull out the main plug.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢
➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢									➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢
		Required in IEC-950 (EN 60 950) - Europe
		• The equipment should be installed near an accessible socket outlet for easy disconnection.
		Required in Appendix ZB of BS 7002 (En 60 950) — United Kingdom
			MAINS PLUG WIRING INSTRUCTIONS
		The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable
		(moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse
		to BS1362 marked	or		and of the same rating as the one removed from the plug must
		be used.
		Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without
		the fuse cover fitted.
		In the unlikely event of the socket outlet in your home not being compatible with the plug supplied
		either cut-off the moulded plug (if this type is fitted) or remove by undoing the screws if a rewireable
		plug is fitted and fit an appropriate type observing the wiring code below.
		DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately
		and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted
		elsewhere into a 13A socket outlet as a serious electric shock may occur.
		To fit an appropriate plug to the mains lead, follow the instructions below:
		IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
				GREEN-AND-YELLOW: Earth
				BLUE:		Neutral
				BROWN:		Live
		As the colours of the wires in this mains lead may not correspond with coloured markings
		identifying the terminals in your plug, proceed as follows:
		The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug
		which is marked with the letter E, or by the safety earth symbol					Å@	, or coloured green or green-
		and-yellow.
		The wire which is coloured BLUE must be connected to the terminal which is marked with the letter
		N or coloured black.
		The wire which is coloured BROWN must be connected to the terminal which is marked with the
		letter L or coloured red.
		If you have any doubt, consult a qualified electrician.
		WARNING: THIS APPARATUS MUST BE EARTHED.
	➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣➢➣

Warning:

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Warranty

While every effort has been made to make this document as accurate and helpful as possible, Olivetti S.p.A. makes

no warranty of any kind with regard to its content. All information included herein is subject to change without notice. Olivetti is not responsible for any loss or damages, direct or indirect, arising from or related to the use of this operation manual. © Copyright Olivetti S.p.A. 2006. All rights reserved. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under copyright laws.