Onkyo TX-SA705 Zone 2—Continued, Using Zone, Controlling Zone 2 with the Remote Controller

Zone 2—Continued

Using Zone 2

This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2.

Controlling Zone 2 from the AV receiver/AV amplifier

1 2

1To turn on Zone 2 and select an

input source, press the [ZONE 2] button repeatedly.

Alternatively, press the [ZONE 2] button followed by an input selector button within 8 seconds.

Zone 2 turns on, the ZONE 2 indicator lights up, and the ZONE 2 12V TRIG- GER OUT goes high (+12 V).

To select AM or FM press the [TUNER] input selector button repeat- edly (TX-SR705 only).

To select the same source as that of the main room, press the [ZONE 2] button repeatedly until “Z2 Sel: Source” appears.

2To turn off Zone 2, press the ZONE 2 [OFF] button.

Note:

While Powered Zone 2 is being used, listening modes that require surround back speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES, and THX Select2 Cinema, are unavailable.

Controlling Zone 2 with the Remote Controller

ON

INPUT

SELECTOR

ZONE 2

LEVEL –/+

Note:

• To control Zone 2, you must press the remote control- ler’s [ZONE 2] button first.

1	Press the [ZONE 2] button, then
	point the remote controller at the
	AV receiver/AV amplifier and
	press the [ON] button.

Zone 2 turns on, the ZONE 2 indicator lights up, and the ZONE 2 12V TRIG- GER OUT goes high (+12 V).

2To select an input source for

Zone 2, press the [ZONE 2] but- ton, followed by an INPUT SELECTOR button.

To select AM or FM press the [TUNER] INPUT SELECTOR button repeatedly.

3To turn off Zone 2, press the

[ZONE 2] button, followed by the [STANDBY] button.

101