Onkyo TX-SA705 Advanced Setup—Continued, Changing the AV Receiver/AV Amplifier’s ID, Enter

Advanced Setup—Continued

.Changing the AV Receiver/AV Amplifier’s ID

1Press the [RECEIVER] button fol-

lowed by the [SETUP] button.

The main menu appears onscreen.

2 Use the Up and Down []/[ ]

Note:

This procedure can also be performed on the AV receiver/AV amplifier by using its [SETUP] button, arrow buttons, and [ENTER] button.

ENTER

ENTER

buttons to select “7. Hardware Setup,” and then press [ENTER].

The Hardware Setup menu appears.

7. Hardware Setup

1. Remote Control

2. Zone2

3.Tuner

4.Analog Multich

5.HDMI

3	Use the Up and Down [ ]/[ ]
	buttons to select “1. Remote
	Control,” and then press
	[ENTER].
	ENTER
	The Remote Control menu appears.
	7–1. Remote Control
	Remote ID	1
	ENTER

4 Use the Left and Right [ ]/[ ]

buttons to select a value.

Remote ID

With this setting, you can change the AV receiver/AV amplifier’s remote con- trol ID. You may need to change this if the remote controller’s control codes overlap with those of another Onkyo component located in the same room. If you change the AV receiver/AV amplifier’s remote control ID, be sure to set the same ID on both the AV receiver/AV amplifier and remote con- troller (see page 98). The default ID for both is 1.

94