Onkyo TX-SA705 First Time Setup—Continued, Notes, “Yes” means that the speaker was, was detected

First Time Setup—Continued

2

3

Put the speaker setup micro- phone at measurement point 

(page 54), and connect it to the SETUP MIC jack.

Auto Speaker Setup AUDYSSEY

Please place microphone at center

of listening area at ear height.

Push Enter : Next

Notes:

•Make sure the microphone is hori- zontal.

•If there’s an obstacle between the microphone and any speaker, the automatic setup will not work cor- rectly. Set up the room as you would when enjoying a DVD.

•Positioning the microphone close to where your ears would normally be will provide better results. You can adjust the height of the microphone by using a tripod or level table.

Press [ENTER].

The automatic speaker setup starts.

Auto Speaker Setup AUDYSSEY

Do not unplug microphone.

Please keep quiet.

Now Measuring. . .

A test tone is output by each speaker in turn, as the Audyssey MultEQ XT function determines which speakers are connected. This takes a few minutes.

Note:

If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so don’t make any noise.

4The speaker detect results appear.

		Auto Speaker Setup			AUDYSSEY
	- - - - - SP Detect Result - - - - -
	FL	: Yes	FR	: Yes
	SL	: Yes	SR	: Yes
	SBL	: Yes	SBR	: Yes
	C	: No	SW	: Yes
	Next
	Retry
	Cancel
	“Yes” means that the speaker was
	detected. “No” means that no speaker
	was detected.
	If you agree with the results, use
	the Up and Down [			]/[	] but-
ENTER	tons to select Next, and then
	press [ENTER].

The options are:

Next:

Proceed to the next step.

ENTERRetry:

Return to step 2 and try again.

Cancel:

Cancel the automatic speaker setup.

5The following screen appears.

Auto Speaker Setup AUDYSSEY

Please place microphone at 2nd Position at ear height.

Push Enter : Next

Place the setup microphone at the next position (page 54), and then press [ENTER].

Audyssey MultEQ XT performs more measurements. This takes a few min- utes.

Auto Speaker Setup AUDYSSEY

Do not unplug microphone.

Please keep quiet.

Now Measuring. . .

6When prompted, place the setup microphone at the next position, and repeat step 5.

55