Onkyo TX-SA705 Advanced Setup—Continued, Low-PassFilter for the LFE Channel, Notes

Advanced Setup—Continued

5	Use the Up and Down [ ]/[	]
	buttons to select “Front,” and
	then use the Left and Right [	]/

[ ] buttons to select a crossover

ENTER

frequency.

Note:

If the Subwoofer setting in step 4 is set to No, this setting is fixed at Full Band.

ENTER

9

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Surr Back Ch,” and then use the Left and Right []/[ ] buttons to select:

1ch: Select if one surround back

speaker is connected.

2ch: Select if two (left and right) surround back speakers are connected.

Note:

If the Surr Back Setting in step 8 is set to None, this setting cannot be selected.

Continue with step 10 below.

6

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Center,” and then use the Left and Right []/ [ ] buttons to select a crossover frequency.

If no center speaker is connected, select None.

Note:

If the Front setting in step 5 is set to anything other than Full Band, Full Band cannot be selected here.

Low-Pass Filter for the LFE Channel

This setting is not set automatically by the Automatic Speaker Setup function (see page 54).

With this setting, you can specify the cutoff frequency of the LFE channel’s low-pass filter (LPF), which can be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.

*If you’re using THX-certified speakers, select 80 Hz (THX).

10

Use the Up and Down [ ]/[ ] buttons to select “LPF of LFE,”

7

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Surround,” and then use the Left and Right []/[ ] buttons to select a crossover frequency.

If no surround left and right speakers are connected, select None.

Note:

ENTER

and then use the Left and Right []/[ ] buttons to select a low- pass filter frequency.

The following low-pass filter frequen- cies can be selected: 80 Hz (THX), 90 Hz, 100 Hz, or 120 Hz.

Continue with step 11 on page 79.

ENTER

If the Front setting in step 5 is set to anything other than Full Band, Full Band cannot be selected here.

ENTER

8

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Surr Back,” and then use the Left and Right []/[ ] buttons to select a crossover frequency.

If no surround back speakers are con- nected, select None.

Notes:

•If the Surround setting in step 7 is set to None, this setting cannot be selected.

•If the Surround setting in step 7 is set to anything other than Full Band, Full Band cannot be selected here.

78