Onkyo TX-SA705 instruction manual 2-11, Advanced Setup—Continued, Speaker Setup, Speaker Settings

Advanced Setup—Continued

Speaker Setup

Some of the settings in this section are set automatically by the Automatic Speaker Setup function (see page 54). Here you can check the settings made by the Automatic Speaker Setup function, or set them manually, which is useful if you change one of the connected speakers after using the Automatic Speaker Setup function.

Note:

1Press the [RECEIVER] button fol- lowed by the [SETUP] button.

The main menu appears onscreen.

The Speaker Setup cannot be carried out while head- phones are connected to the AV receiver/AV amplifier.

Speaker Settings

See “Speaker Settings” on page 46.

Speaker Configuration

This setting is set automatically by the Automatic Speaker Setup function (see page 54).

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Config

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. The following crossover frequencies can be specified: Full Band, 40 Hz, 50 Hz, 60 Hz, 70 Hz, 80 Hz (THX), 90 Hz, 100 Hz, 120 Hz, 150 Hz, or 200 Hz.

Specify Full Band for speakers that can output low-fre- quency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover fre- quency will be output by the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequencies.

Please note that any THX main speakers should be set to Small [80 Hz (THX)]. If you set up your speakers using the Automatic Speaker Setup function, please make sure manually that any THX speakers are set to Small with

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Config,” and then press [ENTER].

The Speaker Config menu appears.

2–2. Speaker Config

Subwoofer			Yes
Front	80Hz
Center	80Hz
Surround	80Hz
Surr Back	80Hz
Surr Back Ch				2ch
LPF of LFE	80Hz
Double Bass		Off

80 Hz (THX) crossover.

2, 3	1
	2-11
1, 12

4	Use the Up and Down [ ]/[ ]
	buttons to select “Subwoofer,”
	and then use the Left and Right
ENTER	[ ]/[ ] buttons to select:

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

ENTER

77