Onkyo TX-SA705 First Time Setup—Continued, Reviewing the Results, Using a Powered Subwoofer

First Time Setup—Continued

Reviewing the Results

	Use the Up and Down [	]/[ ]
	buttons to select the settings that
ENTER	you want to review, and then
	press [ENTER].
	Auto Speaker Setup	AUDYSSEY
	Save
	Review SP Config
	Review SP Distance
ENTER	Review SP Level
	Cancel

The options are:

Review SP Config:

Review the speaker configuration settings.

Auto Speaker Setup
			AUDYSSEY
Review SP Config
Subwoofer	:	Yes
Front	:	Full Band
Center	:	80Hz
Surround	:	100Hz
Surr Back	:	150Hz
Surr Back Ch	:	2ch

Review SP Distance:

Review the speaker distance set- tings.

Auto Speaker Setup
			AUDYSSEY
Review SP Distance
Left	:	15.0ft
Center	:	15.0ft
Right	:	15.0ft
Surr Right	:	7.0ft
Surr Back R	:	7.0ft
Surr Back L	:	7.0ft
Surr Left	:	7.0ft
Subwoofer	:	15.0ft

Review SP Level:

Review the speaker level settings.

Auto Speaker Setup
			AUDYSSEY
Review SP Level
Left	:	+12.0dB
Center	:	0.0dB
Right	:	-12.0dB
Surr Right	:	+3.0dB
Surr Back R	:	+4.0dB
Surr Back L	:	-6.0dB
Surr Left	:	-3.0dB
Subwoofer	:	0.0dB

Press the [RETURN] button to return to the previous menu.

Changing the Speaker Settings Manually

In some situations, the measurements taken by the auto- matic speaker setup may not provide usable results. If running the speaker setup a second time still doesn’t pro- vide usable results, you’ll have to set the speaker settings manually (see pages 77–83).

Notes:

•Please note that any THX main speakers should be set to Small [80 Hz (THX)]. If you set up your speakers using the Automatic Speaker Setup function, please make sure manually that any THX speakers are set to Small with 80 Hz (THX) crossover (see page 77).

•Sometimes due to the electrical complexities of sub- woofers and the interaction with the room, THX rec- ommends setting the level and the distance of the subwoofer manually.

•Sometimes due to interaction with the room, you may notice irregular results when setting the level and/or distance of the main speakers. If this happens, THX recommends setting them manually.

Using a Powered Subwoofer

If you’re using a powered subwoofer, because it outputs very low-frequency sound and its position is usually low, it may not be detected by the automatic speaker setup. If the subwoofer (SW) appears on the SP Detect Result screen as “No,” increase the subwoofer’s volume to the half-way point, set it to its highest crossover frequency, and then try running the automatic speaker setup again. Note that if the volume is set too high and the sound dis- torts, it may not be detected, so use an appropriate vol- ume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct. Refer to your subwoofer’s instruc- tion manual for details.

58