Onkyo TX-SA705 Connecting the AV Receiver/AV Amplifier—Continued, Connecting an RI Dock, Notes

Connecting the AV Receiver/AV Amplifier—Continued

Connecting an RI Dock

■iPod with video

Connect your RI Dock’s analog audio output jacks and Video output jack to the AV receiver/AV ampli- fier’s GAME/TV IN L/R jacks and GAME/TV IN V jack. (Onkyo DS-A2 hookup shown below.)

VIDEO	AUDIO
OUT	OUT
L	R

■iPod without video

Connect your RI Dock’s analog audio output jacks to the AV receiver/AV amplifier’s TAPE IN L/R jacks. (Onkyo DS-A2 hookup shown below.)

AUDIO

OUT

L R

■If you have an Onkyo DS-A1 RI Dock

•Connect its video output jack to the AV receiver/AV amplifier’s GAME/TV IN S jack.

•Enter the appropriate remote control code before using the AV receiver/AV amplifier’s remote controllers for the first time (see page 104).

Notes:

•Connect the Remote Interactive Dock with an cable (see page 43).

•Set the Remote Interactive Dock’s RI MODE switch to HDD or HDD/DOCK.

•Set the AV receiver/AV amplifier’s input display to DOCK (see page 50).

•Refer to the Remote Interactive Dock’s instruction manual.

Connecting the Power Cords of Other Components (North American and European models only)

The AV receiver has AC outlets on its rear panel that can be used to connect the power cords of other components that you intend to use with the AV receiver. These com- ponents can then be left turned on so that they turn on and off as and when the AV receiver is set to On or Standby.

Caution:

• Make sure that the total capacity of the components that you connect to the AC OUTLETS does not exceed the stated capacity (e.g., TOTAL 120 W).

Notes:
•	Onkyo components connected via	should be con-
	nected directly to a wall outlet, not an AC OUTLET
	on the AV receiver.
•	The number of AC OUTLETS, socket type, and total
	capacity depends on the country in which you pur-		European model	North American model

chased the AV receiver.

42