Onkyo TX-SA705 First Time Setup—Continued, Speaker Settings, Notes, Use the Up and Down

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto- matic speaker setup again (see page 54).

If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms (not North American models).

If you’ve connected your front speakers to the FRONT SPEAKERS and SURR BACK SPEAKERS terminal posts for bi-amping, you must change the Speakers Type setting. For hookup information, see “Bi-amping the Front Speakers” on page 24.

Notes:

4

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Speaker Impedance,” and then use the Left and Right []/[ ] buttons to select:

4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.

6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms.

•When bi-amping is used, the AV receiver/AV ampli- fier is able to drive up to 5.1 speakers in the main room.

•Before you change these settings, turn down the vol- ume.

1 Press the [RECEIVER] button, followed by the [SETUP] button.

The main menu appears onscreen.

5

ENTER

ENTER

Use the Up and Down [ ]/[ ] buttons to select “Speakers Type,” and then use the Left and Right []/[ ] buttons to select:

Normal: Select this if you’ve con- nected your front speakers normally.

Bi-Amp:Select this if you’ve con- nected your front speakers for bi-amped operation.

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Config

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

6Press the [SETUP] button.

The Setup menu closes.

Note:

This procedure can also be performed on the AV receiver/AV amplifier by using its [SETUP] button, arrow buttons, and [ENTER] button.

3	Use the Up and Down [ ]/[ ]
	buttons to select “1. Speaker Set-
	tings,” and then press [ENTER].
ENTER	The Speaker Settings menu appears.
	2–1. Speaker Settings
	Speaker Impedance	6 ohms
	Speakers Type	Normal
ENTER

46