Onkyo TX-SA705 instruction manual Zone 2—Continued, Using a Multiroom Kit with Zone, Main room

Zone 2—Continued

Using the Remote Controller in Zone 2 and Multiroom Control Kits

To control the AV receiver/AV amplifier with the remote controller while you’re in the Zone 2 room, you’ll need a commercially available multiroom remote control kit.

•Multiroom kits are made by Niles and Xantech. These kits can also be used when there isn’t a clear line of sight to the AV receiver/AV amplifier’s remote sensor, such as when it’s installed inside a cabinet.

Using a Multiroom Kit with Zone 2

In this setup, the IR receiver in Zone 2 picks up the infra- red signals from the remote controller and feeds them through to the AV receiver/AV amplifier in the main room via the connecting block.

IR IN

IR receiver Connecting

block

Remote controller

Main room Zone 2

Signal flow

The miniplug cable from the connecting block should be connected to the AV receiver/AV amplifier’s IR IN jack, as shown below.

From the connecting block

Miniplug cable

AV receiver/AV amplifier

Using a Multiroom Kit with a Cabinet

In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver/AV amplifier located in the cabinet via the con- necting block.

IR receiver Connecting

block

IR IN

Inside
cabinet	Remote controller
Signal flow

103