Panasonic AJ-HPX3100G Clear the uploaded metadata, Selecting the USER CLIP NAME recording method

Selecting the USER CLIP NAME recording method

Select META DATA > USER CLIP NAME from the thumbnail menu to select the recording method. Two options are available: TYPE1 and TYPE2.

z TYPE1 (Factory setting)

	USER CLIP NAME to be
	recorded
If clip metadata has been read in	Uploaded data
If no clip metadata has been read	Same as GLOBAL CLIP ID
in or if the setting for recording	(UMID data)
clip metadata has been turned off

z TYPE2

	USER CLIP NAME to be
	recorded
If clip metadata has been read in	Uploaded data + COUNT
	value*
If no clip metadata has been read
in or if the setting for recording	Same as CLIP NAME
clip metadata has been turned off

*The COUNT value is indicated as a four-digit number. The COUNT value is incremented each time a new clip is captured if clip metadata has been read in and TYPE2 has been selected as the recording method.

The COUNT value can be reset using the following procedure.

Select META DATA > PROPERTY from the thumbnail menu, then select USER CLIP NAME to display the menu shown below. Select “COUNT RESET” with the cursor and press the SET button to reset the COUNT value to 1.

‹Note

When a P2 card with a memory capacity of 8 GB or more is used in camera-recorder and a one-time continuous recording exceeds the prescribed duration (DVCPRO HD and the AVC- Intra 100: about 5 minutes; DVCPRO50 and the AVC-Intra 50: about 10 minutes; DVCPRO or for DV: about 20 minutes) or when a one-time recording extends over more than one P2 card, the recording concerned will automatically be undertaken as a separate clip. At this time, each clip will be provided with its own COUNT value.

Example of recording (DVCPRO HD) a clip on one P2 card:

REC start					Recording pause
		Recording duration = Approx. 7 min.
			Clip 1	Clip 2
			COUNT value	COUNT value
	= 0001			= 0002
			5 min.		2 min.
Example of recording a clip on two P2 cards:
REC start					Recording pause
			Clip 1		Clip 2
			COUNT value		COUNT value
	= 0003			= 0004
			1st card		2nd card

If the clip thumbnails are displayed as shown in the example above or their properties are indicated using a P2 device, the thumbnail and COUNT value of clip 1 will be displayed.

Clear the uploaded metadata

Select META DATA > INITIALIZE from the thumbnail menu, and press the SET button. Select “YES” when the confirmation screen is displayed.

‹Notes

zJapanese or Chinese characters indicated in English or other characters that cannot be indicated in English will not display properly; they will be indicated as ¢.

zThe letters which can be input with AJ-HPX3100 are only the alphanumeric. AJ-HPX3100 cannot input Japanese and Chinese.

130 Manipulating Clips with Thumbnails: Thumbnail Manipulations Overview