8.MODEL

This section indicates the model of the P2 card that originally contained data on the partition.

‹Note

Press the cursor button (!) to switch to the PARTITION NAME. Press the cursor button (") button to return to the original model name display.

9.DATE/TIME

This section indicates the date and time the data on the partition was recorded.

10.SERIAL

This section indicates the serial number of the P2 card that originally contained the data on the partition.

11.VERIFY

This section indicates the verification setting and results at the time the data on the partition was recorded.

ON:FINISHED :

Verification was performed and the results agreed.

ON:FAILED :

Verification was performed and the results did not agree.

OFF :

No verification was performed.

- - - :

No verification information is available.

‹Notes

zEven for a FAT-type hard disk drive, the 1001st or later clips are not shown.

zFor a FAT-formatted hard disk drive, the information about only the first partition is shown.

zFor a P2 STORE (AJ-PCS060G) that has an invalid partition, that partition information is shown in gray.

12.NAME

This section indicates the PARTITION NAME. Enter the PARTITION NAME from the software keyboard by selecting [CHANGE PARTITION NAME] in the OPERATION MENU while the thumbnail of the hard disk drive is displayed. (Max. 20 characters)

Formatting a hard disk drive

1 Switch the mode to USB HOST.

>[Switching to the USB HOST mode] (page 137)

2 Connect the hard disk drive via USB.

3 Press the THUMBNAIL button to display the thumbnail screen.

4 Press the THUMBNAIL MENU button and select HDD > EXPLORE from the thumbnail menu.

The display provides a screen that shows the information about the hard disk drive.

5 From the menu, select OPERATION > FORMAT (HDD) and select YES using the cursor buttons and SET button. Then, the confirmation message is displayed again. Select YES.

The camera-recorder starts formatting the hard disk drive. Once formatted, the hard disk drive can be treated as a TYPE-S HDD.

‹Notes

zFormatting a hard disk drive erases all contents of it. Note that you cannot erase the contents of certain partitions by specifying them.

zOperation of the hard disk drive with this unit, and the data in the hard disk drive are not guaranteed if a hard disk drive formatted by this unit is rewritten using another PC or similar.

zData erased by formatting cannot be restored, so be sure to perform the format after first confirming the data.

device external with Connection

Connection with external device: Connection with external devices using the USB 2.0 port 139