6 Select YES.

zThis starts the write process.

zWhen the writing is completed, the message “COPY COMPLETED!” is displayed.

<For your information>

To disable verification during writing, select HDD > SETUP from the thumbnail menu and set the option VERIFY to OFF. This speeds up writing without verifying data writing.

‹Note

If a clip is written back to a P2 card different from the original card that contained that clip, then the clip may be incomplete. If this is the case, reconnect the clip.

>[Reconnection of Incomplete Clips] (page 127).

Direction for using a hard disk drive

zA hard disk drive (including the P2 STORE (AJ-PCS060G)) must be used under the following conditions:

ŠIt must meet the operating requirements (e.g. temperature).

ŠIt must not be placed in an instable place or a place exposed to vibrations.

zSome hard disk drives and cables do not operate properly.

zSome hard disk drives with the SATA (Serial ATA) interface or the PATA (Parallel ATA) interface connected by a USB conversion cable may not be recognized.

zWhen copying data, a hard disk drive must have sufficient free space.

zDo not remove the cable or the target P2 card or turn off the camera-recorder or hard disk drive during formatting or copying. Doing so requires the camera-recorder and the hard disk drive to be reactivated. Furthermore, ensure that the unit is fully charged, or use an external DC power source.

zSince hard disk drives are high precision devices, there is a high possibility that they may become incapable of writing data depending on the conditions of use.

zTake note that we will not be liable for loss of data caused by failed hard disk drives or any other problem as well as direct or indirect damages resulting from the loss of data.

zWe do not guarantee that hard disk drives will operate properly with the camera-recorder or that the data on them will be properly retained if data copied to them from the camera-recorder has been replaced with other data using a PC.

zBy using the drive mount converter distributed on the following URL, the hard disk drive can be mounted in the designated folder when connected.

http://pro-av.panasonic.net/

device external with Connection

Connection with external device: Connection with external devices using the USB 2.0 port 141