Parts and their Functions

Power Supply and Accessory Mounting Section

14

4

12

78 5 9 6 1

1.POWER switch

Used to turn on/off the power.

2.Battery mount

A battery pack from Anton/Bauer is mounted here.

>[Mounting the Battery and Setting the Battery Type] (page 109)

3.DC IN (external power input) socket (XLR, 4P) camera-recorder is connected to an external DC power supply.

>[Use of the external DC power supply] (page 110)

4.LIGHT switch

Choose a way to turn the video light connected to the 16.LIGHT connector ON/OFF.

AUTO: If you leave the video light POWER switch ON, then the light will light at the same time that this unit starts recording, and the light will go out at the same time recording stops.

MANUAL: The light will light according to whether the video light POWER switch is ON/OFF.

17

15

14

13

16

18

2

10

311

8.Lens cable/microphone cable clamp

This clamp secures the lens and microphone cables.

>[Mounting the Lens and Performing the Flange Back and White Shading Adjustments] (page 111)

9.Tripod mount

When you want to mount camera-recorder on a tripod, the optional tripod adapter (SHAN-TM700) is attached here.

>[Mounting the Camera on a Tripod] (page 115)

10.LENS jack (12-pin)

The lens connection cord is connected here. For a detailed description of your lens, see the relevant manufacturer’s instruction manual.

11.DC OUT (DC power supply) output socket

This output socket is designed for 12-VDC. It provides a maximum current of 1.5 A.

Connect an external switch to this socket to control REC starts and stops or an LED for use as a tally lamp.

>[Connection of the DC OUT connector and the external REC strat/stop switch] (page 117)

5.Lens mount (bayonet 2/3-type)

The lens is attached here.

>[Mounting the Lens and Performing the Flange Back and White Shading Adjustments] (page 111)

6.Lens lever

Lower this lever to lock the lens to the lens mount.

>[Mounting the Lens and Performing the Flange Back and White Shading Adjustments] (page 111)

7.Lens mount cap

‹Note

Confirm the pin arrangements of the DC output connector of the external DC power supply and the DC IN socket on the unit, and connect the proper polarities to each other.

If the 12 V power supply is connected to the GND connector in error, it may cause a fire or failure of the unit.

To remove the cap, raise the 6. lens lever.

When the lens is not mounted, replace the cap.

16 Parts and their Functions: Power Supply and Accessory Mounting Section