Preparation
Inserting/Removing the Battery
•Check that the camera is turned off.
•Close the flash.
1 Slide the release lever in the direction of the arrow (OPEN side) and then open the battery door.
3 1 Close the battery door.
2Slide the release lever in the direction of the arrow (CLOSE side) and then close it firmly.
1
SE | OP |
LO | EN |
C |
|
2 |
|
SE | OP |
LO | EN |
C |
|
•Always use genuine Panasonic batteries
2Insert:
Insert the charged battery fully until it clicks.
Remove:
Push the lever A in the direction of the arrow to remove.
A 
•Be careful of the direction indicated by
the mark [ 
] on the battery when inserting the battery.
20
•Remove the battery after use.
•When a fully charged battery has been inserted for more than 24 hours, the clock setting is stored (in the camera) for at least 3 months even if the battery is removed. (If you insert a battery that is not sufficiently charged, the length of time that the clock setting is stored may be shorter.) The clock setting is canceled after this length of time. In this case, set the clock again. (P28)
•Do not remove the card or the battery while the card is being accessed. The data may be damaged. (P22)
•Turn the camera off and then remove the battery after the LCD monitor and the status indicator (green) turn off. If you remove the battery while the camera is on, the settings on the camera may not be stored properly.
•The supplied battery is designed only for the camera. Do not use it with any other equipment.
VQT0W82
