
Others
•You cannot attach the MC protector and the PL filter at the same time.
•If the MC protector/PL filter are tightened too much, you may not be able to remove them. Do not tighten them too much.
•When taking pictures with the flash using the MC protector or PL filter, vignetting effect may occur.
•If the MC protector/PL filter are dropped, they may be destroyed. Be careful not to drop them when attaching them to the camera.
•You can attach the lens cap or the lens hood when the MC Protector and the PL Filter are attached.
•Read the operating instructions of the MC protector or the PL filter for details.
•MCu“Multi-coated”
PLu“Polarizing lens filter”
Using the Remote Shutter
If you use the remote shutter
1 Firmly connect the remote shutter to the [V OUT/REMOTE] socket on the camera as far as it will go.
V OUT / | USB |
REMOTE |
|
2 Take a picture.
1: Press the button lightly to press halfway.
2: Press the button fully to take the picture. (Press it as far as it will go.)
∫About [LOCK] on the remote shutter
• You can keep the shutter button pressed fully. This is effective when taking pictures with [B] (Bulb) (P39) or in burst mode (P64).
• While pressing the shutter button fully, slide it to the [LOCK] side.
•Slide it to the other side to cancel [LOCK].
•Do not use any other remote shutters except
•You cannot operate the camera with the remote shutter in the following cases.
–When the power save mode is canceled
–When you determine the part to be trimmed
–When you determine the aspect ratio conversion
107
VQT0W82