Preparation
[BEEP]
Press [ MENUSET ] to display the [SETUP] menu and select the item to set. (P27)
Set the volume of the focus confirmation beep, the
beep. |
| |
[ | ]: | No beep |
[ | ]: | Soft beep |
[ | ]: | Loud beep |
[NO.RESET]
Press [ MENUSET ] to display the [SETUP] menu and select the item to set. (P27)
Set this when you want the file number of the next recording to start from 0001. (The folder number is updated and the file number starts from 0001.)
•A folder number between 100 and 999 can be assigned.
When the folder number reaches 999, the number cannot be reset. We recommend formatting the card after saving the data on a PC or elsewhere.
•To reset the folder number to 100, format the card first (P97) and then use this function to reset the file number.
A reset screen for the folder number will then appear. Select [YES] to reset the folder number.
•Refer to P99 for detailed information about the file number and the folder number.
[RESET]
Press [ MENUSET ] to display the [SETUP] menu and select the item to set. (P27)
The following settings are reset to the initial settings.
–[REC] mode menu settings
–[SETUP]/[CUSTOM] menu settings
•The following settings are also reset when you select [RESET].
–[FILM MODE] (P76)
–[CUST. SET MEM.] (P87)
–[WORLD TIME] (P108)
–[FAVORITE] in the [PLAY] mode menu (P90)
•The folder number and the clock setting are not changed.
[USB MODE]
Press [ MENUSET ] to display the [SETUP] menu and select the item to set. (P27)
Select the USB communication system after or before connecting the camera to your PC or your printer with the USB connection cable (supplied). (P98, 100)
[ 
SELECT ON CONNECTION]:
Select either [PC] or [PictBridge (PTP)] if you connected the camera to a PC or a printer supporting PictBridge.
[ 
PC]:
Set after or before connecting to a PC.
[ 
PictBridge (PTP)]:
Set after or before connecting to a printer supporting PictBridge.
•When [PC] is selected, the camera is connected via the “USB Mass Storage” communication system.
•When [PictBridge (PTP)] is selected, the camera is connected via the “PTP (Picture Transfer Protocol)” communication system.
[HIGHLIGHT]
Press [ MENUSET ] to display the [SETUP] menu and select the item to set. (P27)
[ON]: When the auto review function is activated, white saturated areas appear blinking in black and white.
[OFF]: No highlight feature.
[ON][OFF]
•If there are any white saturated areas, compensate the exposure towards negative (P40) referring to the histogram (P52) and then take the picture again. It may result in a better quality picture.
29
VQT0W82
