Panasonic KX-BP800 Installation, Screen film, Markers, Erasers, Thermal, Transfer film

	Precautions
Installation	CDo not install the unit where it may be exposed to direct sunlight, near heating
	equipment, or near air-conditioning vents as this may cause stretching and/or
	discoloration of the screen.

CDo not install the unit in locations having a temperature of 10°C (50°F) or lower or where the temperature may change suddenly as this may disable the unit’s ability to make copies.

Screen film	CMake thick and dark lines inside the copying		25mm (1")
	area. Note that any writing inside the
	shaded area on the right figure cannot	35mm	Copying area	35mm
	be copied.
		(13/8")		(13/8")
			25mm (1")
	CUse a commercially available white board cleaner for hard-to-erase stains.
	(SANFORD® EXPO® white board cleaner etc.)

CDo not erase with an overly dirty eraser. (See page 65.)

CDo not allow writing to remain on the screen for an extended period of time as it will become harder to erase.

CPeriodically wipe the screen film gently with a water-dampened cloth that has been thoroughly wrung. (See page 65.)

CDo not touch the screen, write with markers, or erase while the screen is moving as this may result in damage to the unit.

Markers,	CUse only the included or designated markers, erasers and thermal transfer film.
Erasers and	(See page 71.)
Thermal	Use of accessories other than those included or designated (such as oil-based
	markers) may damage the screen or result in hard-to-erase markings.
transfer film

CCopy quality increases with the thickness of the drawn line. To ensure quality copies, please use the markers (Big).

CThe markers for interactive (Small) draw thin lines. The quality of the copies may be reduced when these markers are used.

CDo not store the thermal transfer film in a location subject to extreme changes in temperature (such as near air conditioning or heating equipment) as this may cause condensation on the thermal transfer film and result in poor print quality and/or paper jams.

CStore markers horizontally as vertical storage may stop the ink from coming out.

CThe length of one roll of designated thermal transfer film (Replacement film : KX- BP081 or KX-BP082) is approximately 100 meters (328.1'). One roll of thermal transfer film can make approximately 300 sheets of copies.

Note that the total number of copies may differ depending on the operating conditions.

Also note that the length of the thermal transfer film supplied with the unit is shorter than the replacement film roll and is only approximately 20 meters (65.6').

SANFORD® and EXPO® are registered trademarks of Sanford corporation.

Before you start

Help

9