10. Multi-unit Operation
74
4Select the desired base unit number, or
“Auto”, then press {>}.
LThe handset starts searching for the base
unit.
10.2.4 Cancelling a handset
A handset can cancel its own registration (or the
registration of another handset) that is stored in
the base unit. This will allow the base unit to
forget the handset.
1Press {j/OK}.
2Select “Base Unit Setup”, then press
{>}.
3Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page 71).
4Enter “335”.
5Select “Cancel Handset”, then press
{>}.
LThe numbers of all handsets registered to
the base unit are displayed.
6Select the handset(s) you want to cancel, by
pressing the desired handset number.
LThe selected handset number(s) will
flash.
LTo cancel a selected handset number,
press the number again. The number will
stop flashing.
7Press {j/OK}.
8Select “Yes”, then press {>}.
10.2.5 Cancelling a base unit
A handset can cancel a base unit that it is
registered to. This allows the handset to forget
the base unit.
1Press {j/OK}.
2Select “Handset Setup”, then press {>}.
3Select “Registration”, then press {>}.
4Enter “335”.
5Select “Cancel Base”, then press {>}.
6Enter “0000” (default handset PIN).
LIf you changed the PIN, enter it (page 69).
7Select the base unit(s) you want to cancel, by
pressing the desired base unit number.
LThe selected base unit number(s) will
flash.
LTo cancel a selected base unit number,
press the number again. The number will
stop flashing.
8Press {j/OK}.
9Select “Yes”, then press {>}.
10 Press {ih}.
Note:
LTo register the handset to another base unit
or to the same base unit again, see manual
registration on page 73.
10.2.6 Increasing the range of
the base unit
You can increase the range of the base unit by
using a DECT repeater. Please use only
Panasonic DECT repeater. See page 9 for
accessory information.
Important:
LBefore registering the repeater to this
base unit, you must turn the repeater
mode ON.
Setting the repeater mode
1. Press {j/OK}.
2. Select “Base Unit Setup”, then press
{>}.
3. Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page 71).
4. Select “Other Options”, then press {>}.
5. Select “Repeater Mode”, then press {>}.
6. Select “On” or “Off” (default), then press
{>}.
7. Press {ih}.
Note:
LAfter turning repeater mode ON/OFF, you will
not be able to make or receive calls for a few
moments.
10.3 Handset locator
Using this feature, you can locate the handset if
it has been misplaced.
LKeep the front cover page open for button
locations.
1Press {LOCATOR}.
LThe base unit will page the handset for
about 1 minute.
2To stop paging, press {LOCATOR} on the
base unit or {ih} on the handset.
Note:
LThis feature is not available while using
{DIGITAL SP-PHONE}.
FC238HK-PFQX2217ZA_en.book Page 74 Wednesday, July 27, 2005 11:02 AM