Operations

Multi-Function Center

 

 

 

Problem

Cause & Remedy

The facsimile unit cannot print

¡“Panasonic MFC Print” was not selected as your printer. Select it.

documents from your PC.

¡The print manager of Windows 3.1 was not used. Test using

 

Notepad in Windows 3.1 or Wordpad in Windows 95.

 

 

The facsimile unit cannot print the

¡Another device is in use. Check the outbox, then wait until the

documents received on your PC.

other device is finished or cancel it.

 

¡The com port was set improperly. Check the properties and set the

 

com port with “Test” again.

 

¡The com port is competing with the mouse or network card, or uses

 

the same IRQ as MFC-Print. Change the IRQ setting (refer to your

 

Windows user manual).

 

¡The performance of your PC is not sufficient. At least, CPU386 (DX

 

33MHz) and 4M RAM are necessary.

 

¡An OS (Macintosh, DOS, Win NT, etc.) which the Multi-Function

 

Center does not support was used. Use Windows 95 or

 

Windows 3.1/3.11.

 

¡All com ports are in use. Assign a com port for the Multi-Function

 

Center.

 

 

Documents are received by the

¡The Inbox was set to pause. Remove the check mark from the

facsimile unit but I want to receive

Pause Inbox in the Message Center window.

them on the PC.

¡The PC link feature (#14) of the facsimile unit is set to OFF. Set to

 

ON (see page 93).

 

¡The Message Center is not running. Open it.

 

 

Documents are received on the PC

¡The Inbox was not set to pause. Set the Inbox to pause or close

but I want to receive them on the

the Message Center.

facsimile unit.

¡The Message Center is running. Remove the check mark on the

 

Load in Message Center with Windows property.

 

 

I want to print a received fax with the

¡Select Automatically Print Incoming Faxes in the Receive dialog

pre-selected printer.

box of the Inbox properties.

 

 

I want a received fax to be printed by

¡Set the desired printer as default in the Print Settings box, or select

another printer.

the desired printer in the Print dialog box.

 

 

Documents cannot be scanned on

¡See the Viewer instructions in the operating instructions or help list.

the PC.

¡There is not enough hard disk capacity. Delete unnecessary

 

applications or data.

 

¡The MFC scan program was activated when other applications

 

were running and the swap file was full. Check the swap file size

 

and extend the swap file.

 

¡The MFC scan program was activated and there is not enough

 

RAM capacity. Close the applications in progress.

 

¡Try cold reboot.

 

 

Documents cannot be sent by the

¡The receiving unit is busy. Check the outbox and error status log.

PC.

¡The MFC is installed incorrectly. Install it again.

 

¡There is not enough RAM capacity. Try again after closing other

 

applications.

 

¡A different fax software was used instead of the Multi-Function

 

Center.

 

 

Help

For Assistance, Call 1-800-435-7329

103