Setup

Connections

1

Connect the handset cord.

2

Connect the telephone line cord.

3

Connect the power cord.

● When the power is turned on for the first time, the unit will print some basic information.

120 V, 60 Hz

Power cord

(Powerprotectorsurge)

Line surge

)

Telephone

RJ11C ( protector

line cord

Note:

Handset cord

Connect to “LINE”.

●The warranty does not cover damage due to power line surges or lightning.

For additional equipment protection, we recommend the use of a surge protector. The following types are available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).

●When you operate this product, the power outlet should be near the product and easily accessible.

●If the following message is displayed when the unit is plugged in, the recording paper set lever is released.

Display: CHECK LEVER

Move the lever back (see step 3 on page 25).

Automatic dialing mode setting

●When the telephone line cord and the power cord are connected, the unit will automatically start to detect the dialing mode.

Display: CHECKING LINE

Wait until one of the following messages is displayed.

— If your line has touch tone service:

LINE IS TONE

—If your line has rotary pulse dial service:

LINE IS PULSE

●If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when power is restored.

●You can change the dialing mode setting manually. See page 35.

●If you connect the power cord before connecting the telephone line cord, the following messages will be shown alternately.

Display:

INSERT TEL LINE

 

 

 

NO TEL LINE

 

 

 

 

 

 

 

Connect the telephone line cord.

26